What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 08:05
[old diagram got deleted by accident]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The bolt then partially travels down the line to your home.
but this device (an Inductor) … impedes the rapid changes in the current.
He then describes Rainy Season and Lightning.
What is lightning?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
These devices are installed between the “hot” and “neutral” and protective ground.
It also is a device that limits the change in current flow.
What's at the center of Mars? Maybe the stench of rotten eggs - Space
For this case there are devices called Metal oxide varistors (MOV).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Edit 2024–10.
Top Federal Reserve official promises major overhaul of US bank regulation - Financial Times
The third is lightning and “how it gets conducted into a home.”
There are three different concepts here that are getting confused.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Why do I sweat between my legs all the time, top off my legs, all way down?
There are two important concepts here.
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Nintendo Switch 2 Size Comparison vs. Original Switch vs. Steam Deck - Gizmodo
An AC voltage/ current source, and an ac inductive load.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Now when you have a certain ac resistance, then a current flows in a loop.
Upvotes:
(Dc diagram shown, AC is similar).
what exactly is a ‘surge’ protector?
Anthony Richardson sidelined by shoulder injury - NBC Sports
What does a fuse do?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
In schematic diagrams this is the symbol for a fuse:
How do you get a girl to like you?
This is where this question deviates from being a 'generic' question, and becomes more specific.
A circuit breaker is similar, but is resettable.
a photo is worth a thousand words.
Where should Jac Caglianone hit in the Royals order? - Royals Review
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
I post the exact comment here.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
nine
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The MOV will conduct when the voltage exceeds 50% of line voltage.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is where the MOV conducts again, and dissipated the energy.
2024–10–14 [Omar Gharbi Omar Gharbi ]
[image of Common-mode choke]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–16 [ OO OLAOYE OYEBODE ]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This one hit behind the barn.
Because the load is inductive, the current lags the voltage.(by a bit).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But… the neutral is now “floating” because of the 1 ohm resistance.
Barnstars:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Here is a simplified AC power diagram.
One
At least they know the answer if they wanted it.
First Sentence:
It seems Mohan does not understand the difference between a comment and an Answer.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
the problem then depends on "how fast does the fuse operate?".
One is “what exactly is in a ‘surge protector’ ? ”
He then asserts :
2024–10–10[John johnson John Johnson ]
but I think this circuit , shows a few more pieces.
This device then solves the entire problem.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At one ohm, the resistor has a maximum of 1 watt power.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
He then describes the function of a fuse.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
The other is “what does a “fuse” do?”
eight
But it can get overloaded, and no longer works.
so, what happens?
This is 'the assistant's answer'
A fuse is a non-resetable over current circuit protector.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These are simplified answers to the original question, and does not change anything I wrote above.